How to Change the Oil in a 2009 Subaru Impreza

Step-by-Step Guide

1. 1

   Step 1: Make sure that the engine is turned off.

   You will most likely have to raise both front sides, since the filter is located towards the middle., Replace the drain plug and drain plug gasket if necessary., The filter is located where the exhaust pipe makes a loop coming out of the exhaust manifold.
   
   The loop encircles the filter.
   
   If the exhaust is hot, you may burn your hands, so be careful, or better yet use a ratchet with an extension and a cup, available from the dealer., Wipe off the area, wet the gasket of the new filter with some oil, and install the new filter.,,, Add small amounts of oil until the the level on the dipstick is correct.
2. 2

   Step 2: Pull the hood release latch

3. 3

   Step 3: located under the steering wheel

4. 4

   Step 4: close to the edge of the driver's door.

5. 5

   Step 5: Engine Open the hood and allow it to rise fully.

6. 6

   Step 6: Raise the car in a position that is convenient to reach the oil pan and oil filter.

7. 7

   Step 7: Place a drain pan or suitable container under the drain plug of the oil pan and remove the drain plug with a wrench or ratchet

8. 8

   Step 8: allowing the old oil to drain.

9. 9

   Step 9: Move the drain pan under the oil filter.

10. 10

    Step 10: Remove the oil filter

11. 11

    Step 11: making absolutely sure that the oil filter gasket is removed as well.

12. 12

    Step 12: Add new oil

13. 13

    Step 13: starting with 3.5 liters (0.9 US gal).

14. 14

    Step 14: Start the engine and let it run a few seconds to allow the oil to circulate in the engine and fill the new filter.

15. 15

    Step 15: Check the oil level on the dipstick

16. 16

    Step 16: which has an orange/yellow plastic handle.

Detailed Guide

About the Author