How to Scrunch Thin Hair Overnight
Take a shower., Wrap your hair up in a towel and get dressed and what not. , After about two minutes, while your hair is still pretty wet, take it out of the towel. , Part your hair where you want it. , Brush your hair so there are no tangles or...
Step-by-Step Guide
-
Step 1: Take a shower.
Start with the bottom section.
Don't get it on your roots, or else your hair will look greasy. , Use curl shaping gel with extra strong hold. , Make sure the braid is as tight as you can get it. ,, Again, don't get any of the products on your roots to avoid the greasy look. , Get ready for the day, then respray, then take the braids out. ,, -
Step 2: Wrap your hair up in a towel and get dressed and what not.
-
Step 3: After about two minutes
-
Step 4: while your hair is still pretty wet
-
Step 5: take it out of the towel.
-
Step 6: Part your hair where you want it.
-
Step 7: Brush your hair so there are no tangles or knots.
-
Step 8: Section off your hair into four parts: first into two parts down the middle in the back
-
Step 9: as if you were going to do two pigtails
-
Step 10: and then halfway through the top
-
Step 11: so there is a section on the top
-
Step 12: and a section on the bottom.
-
Step 13: Apply mousse to the first section where you would like to start.
-
Step 14: After you apply the mousse
-
Step 15: apply gel to the same place.
-
Step 16: After the products are in your hair
-
Step 17: braid that section.
-
Step 18: Do those same steps for each section of your hair.
-
Step 19: After all the braids are complete
-
Step 20: spray each braid with hairspray thoroughly.
-
Step 21: When you wake up
-
Step 22: spray the braids with hairspray every few hours.
-
Step 23: When you take the braids out
-
Step 24: put a big wad of gel into your hands
-
Step 25: rub them so it spreads the gel out
-
Step 26: and scrunch your hair all over.
-
Step 27: Spray your hair with hairspray all over so it will last all day.
Detailed Guide
Start with the bottom section.
Don't get it on your roots, or else your hair will look greasy. , Use curl shaping gel with extra strong hold. , Make sure the braid is as tight as you can get it. ,, Again, don't get any of the products on your roots to avoid the greasy look. , Get ready for the day, then respray, then take the braids out. ,,
About the Author
Nicholas Richardson
Committed to making DIY projects accessible and understandable for everyone.
Rate This Guide
How helpful was this guide? Click to rate: