How to Use the Zero 88 Juggler Lighting Desk

Step-by-Step Guide

1. 1

   Step 1: Look at the top row labelled Preset A.

   These are 12 faders that correspond to 12 Dimmer channels that you should have set up.
   
   So sliding up fader 1 will fade lantern 1 into life.
   
   You can fade several lanterns at once.
2. 2

   Step 2: Use the Preset A Master to fade your set-up on Preset A.

   , When Preset A is at 10, Preset B is at zero. ,,, If you set the knob at 5 seconds, your two presets will cross fade from one to the other for 5 seconds.
   
   The maximum fade time is 5 minutes which is perfect for a slow sunrise. ,, Now when you press the buttons, the appropriate light will flash on momentarily. ,,,,,,,,,
3. 3

   Step 3: Look at the two Preset Masters.

4. 4

   Step 4: Set up the change of lights you want on Preset B.

5. 5

   Step 5: Slide the two Preset Masters together and your lights in scene 1 (Preset A) will change to the Lights in scene 2 (Preset B).

6. 6

   Step 6: To use the Fade time knob (above the Preset masters)

7. 7

   Step 7: turn the knob to the desired time and slide the two Preset Masters smartly.

8. 8

   Step 8: Look along the bottom of the desk and you will see a row of flash buttons.

9. 9

   Step 9: Activate the flash buttons by pressing the Flash Master (an LED light should come on).

10. 10

    Step 10: To create a sequence or chase:

11. 11

    Step 11: Press and hold down the sequence button for a few seconds until the LED comes on.

12. 12

    Step 12: Use the shift button to give the sequence a number.

13. 13

    Step 13: If in the corner of the LED screen there is a tiny red dot

14. 14

    Step 14: you know that the memory for that chase number is free.

15. 15

    Step 15: Slide up the first step of your sequence and afterwards press the sequence button again.

16. 16

    Step 16: The number on the screen will have automatically changed to step 2 so slide the second step of your sequence and then press the button.

17. 17

    Step 17: Repeat these steps until you have finished your sequence.

18. 18

    Step 18: To play your sequence

19. 19

    Step 19: press down the sequence button until the little LED begins to flash

20. 20

    Step 20: signalling it has gone into playback mode.

21. 21

    Step 21: Use the two knobs to increase or decrease the speed of the sequence as well as to control the time of the cross fade.

Detailed Guide

About the Author