How to Fix a Car That Stalls

Step-by-Step Guide

1. 1

   Step 1: Consider the complexity of your car before beginning and take your car to a trusted repair shop.

   Modern cars (mid-nineties or later) have an ignition and fuel system that are in large part computer controlled, and it will be difficult for you to make any adjustments.
   
   You will want to take it into the shop to address this problem.
2. 2

   Step 2: Check for check engine lights or maintenance required lights on the dash board instrument cluster.

   Any fuel or ignition problem in modern CPU controlled engine systems will likely cause a code to be displayed, a check engine light, or maintenance required light to come on.
   
   If you are not able to use a scan tool, or don't have access to one, many auto parts retailer offer the use of one free of charge. , Your engine stops running because it is not igniting fuel in the cylinders.
   
   This occurs either because there is not any gas to ignite, or because it lacks the electrical charge to ignite it.
   
   Note that older, carburetor type fuel systems may have too much fuel entering the cylinders, a condition known as flooding. , Does this change the performance of the engine, or cause it to stall? This might indicate a clogged fuel filter.
   
   Replacing the fuel filter can often be relatively cheap and easy once you find out where it is located.
   
   Note that some vehicles have fuel filters located in the gas tank, and can be very difficult to access.
   
   Diesel fuel filters and multi-fuel filters can cost over $100.00, U.S. , If your car has a distributor, you may need to adjust the timing.
   
   With the right tools and know how, this is an easy and free task.
   
   If your vehicle has fuel injection, you can check the injector by using a screwdriver or mechanics scope.
   
   The injectors will make a clicking/snapping sound if working.
   
   No sound may indicate a bad injector.
   
   It could also indicate an electrical failure with the circuit that drives the fuel injector.
   
   Also, check the Ignition Control Module, which controls the timing of the voltage going to spark plugs, and supplies the spark to ignite the fuel/air mixture. , This is effectively a tune-up.
   
   This can usually be done even by a relative novice to car repair, and take a couple of hours with the right tools.
   
   It seems counterintuitive, but even the wires and distributor decay over time, and transmit less electricity.
   
   This tune-up may solve your stalling problem — even if it does not, your car should run better and get better mileage afterwards. , Dieseling describes the situation where you turn off the key, yet the car continues to run for a few seconds or longer, eventually sputtering to a stop.
   
   This does not occur on fuel-injected vehicles because when the ignition is turned off so is the fuel supply to the engine as well as the spark plugs. , Fuel pumps are designed to pump liquid not “vapor” and thus fail to provide enough fuel pressure.
   
   However, a clogged fuel tank vent system can cause a vacuum in the fuel line that causes fuel to eventually stop reaching the engine.
   
   This also is a problem unique to carbureted engines.
   
   Fuel injected engines commonly have "closed loop" fuel delivery systems that make this condition unlikely to occur.
   
   Try opening your gas cap.
   
   If you hear a "whooshing" sound, like when you open a can of coffee, it means the gas tank is not venting properly.
   
   Now try starting the car.
   
   It should work after a couple tries.
   
   This is usually found only in older cars.
   
   If you have it, this will probably happen again, so your tank vent system should be checked for blockage.
   
   More often than not, the problem can be traced to a cheap replacement locking gas cap.
   
   A cheap fix is to drill a small hole in your gas cap to allow air in and prevent the vacuum from forming, but the gas cap should not be left this way.
3. 3

   Step 3: The stall is likely caused by either a problem in the electrical system or in the fuel system.

4. 4

   Step 4: Drive the car up and down steep hills.

5. 5

   Step 5: Does the car idle roughly and stall when at idle?

6. 6

   Step 6: If your car has a distributor

7. 7

   Step 7: you might consider changing the cap

8. 8

   Step 8: wires and plugs.

9. 9

   Step 9: If your car diesels when you turn off the ignition

10. 10

    Step 10: it means that your car most likely has a carburetor and the idle speed adjustment is too high.

11. 11

    Step 11: In rare cases

12. 12

    Step 12: your car may stall due to what is commonly called a "vapor lock

13. 13

    Step 13: " a situation that occurs when the fuel lines supplying gas to the engine become hot enough to boil the gas in the line turning it into vapor.

Detailed Guide

About the Author