How to Make a Wire Wrapped Beaded Flower Ring

Step-by-Step Guide

1. 1

   Step 1: Cut a 25 centimeter piece of soft craft wire.

   Use about 6 centimeters of the wire., Again, use about 6 centimeters of the wire., You should have two petals and a straight piece of wire now., Make sure the base of this petal meets the base of the other petals. ,,,,,,,,,, Lead the two ends of the wire in between the beaded wires and tie the ends together with a firm knot.,, Tie the two ends together with a firm knot., Bend it into a ring shape that is large enough to easily fit around your finger., Cut any remaining pieces of string. , Wear your beautiful accessory with pride.
2. 2

   Step 2: Bend one end of the wire to make it look like a round petal.

3. 3

   Step 3: Bend the other end of the wire like a round petal too.

4. 4

   Step 4: Make sure the base of the petals meet.

5. 5

   Step 5: Bend the end of the straight piece like a round petal.

6. 6

   Step 6: Cut off the remaining piece of wire.

7. 7

   Step 7: Repeat steps 1 to 6 with another piece of wire.

8. 8

   Step 8: Tie a long thin copper wire to one of the petals

9. 9

   Step 9: firmly.

10. 10

    Step 10: Thread small green beads to the wire until the wire is almost full.

11. 11

    Step 11: Tie the remaining piece of wire to the opposite side of the petal.

12. 12

    Step 12: Repeat steps 1 to 3 until the entire petal is filled with small green seed beads.

13. 13

    Step 13: Repeat steps 1 to 4 for the two remaining petals and the second set of petals.

14. 14

    Step 14: Put one set of petals on top of the other.

15. 15

    Step 15: Turn the upper set of petals so that none of the petals are right above each other.

16. 16

    Step 16: Use a thin copper wire to tie the petal sets together.

17. 17

    Step 17: Thread the big rose bead to a thin copper wire.

18. 18

    Step 18: Lead the two ends of the copper wire with the rose in the middle in between the green beaded wires.

19. 19

    Step 19: Take another piece of thin copper wire.

20. 20

    Step 20: Lastly

21. 21

    Step 21: take a small piece of wire and use it to tie the ring to the petal sets.

22. 22

    Step 22: There you go!

Detailed Guide

About the Author