How to Paint a Mailbox

Step-by-Step Guide

1. 1

   Step 1: Remove the mailbox from the wall or post

   It should be screwed on.
   
   Be sure to save the screws some place safe so that you can reattach the mailbox later.
   
   If you cannot remove the mailbox, you will need to cover the post or the surrounding wall with some masking paper and painters tape.
2. 2

   Step 2: if you can.

   This includes the numbers, flag, hook, and latch.
   
   If you can't remove them, then leave them on for now. , Spray the mailbox down with an all-purpose cleaner an scrub it well with a scrubbing sponge.
   
   This will remove all dirt, oils and dust.If you are planning on repainting the post, you will need to clean that too. , If you cleaned the post, be sure to rinse it too. , If you are working on a wooden post, you might use a flat, sanding sponge.
   
   You can also use an electrical sander on the post to get the job done faster.
   
   This will give you a smooth, clean surface to work on.
   
   If you see any rust on the flag, latch, or hook, be sure to clean it off too. , If you don't do this, this dust will get caught in the paint, and give you an uneven, grainy finish. , If you weren't able to remove the hook or latch, cover them with painters tape.
   
   If you weren't able to remove the flag, wrap it with a plastic bag; secure the plastic bag with some painters tape., Choose a dry, windless day to prime and paint your mailbox.
   
   If it is too damp or humid, the paint may not cure properly.
   
   If it is too windy, dust and debris can get caught in the paint.
   
   Paint will dry the fastest on a hot, dry day. , The best place to work would be outside.
   
   If you cannot work outdoors, then be sure to leave a window open so that you do not get a headache.
   
   If you get a headache while painting at any time, step away from your project and take a back.
   
   Return to your project once the headache goes away. , Choose an outdoor quality spray paint primer that is intended for metal.
   
   It does not matter what color your use, but a medium grey seems to give you the most neutral base to work on.
   
   Hold the can 6 to 8 inches (c to c centimeters) away from the surface, and apply the paint using light, even strokes.
   
   Spray using a side-to-side motion.
   
   Over lap each stroke by a little bit; this will help prevent any gaps.If you are planning on painting something that is currently covered up (like the flag) wait until you are completely done priming and painting the mailbox.
   
   Paint the entire mailbox first, then open the flap and paint the rim that's normally covered up by the flap.
   
   Wait until the paint dries before you close the flap, or it will get glued shut.If you weren't able to remove the flag, you will have to paint around the flag.
   
   Do this by painting the mailbox, then moving the flag, and painting the bare patch that was underneath., Not only does this give you a smoother finish, but it prevents any drips and puddles. , Choose an outdoor quality spray paint that is meant for metal.
   
   Hold the can 6 to 8 inches (c to c centimeters) away from the surface, apply a light, even coat using a side-to-side motion.
   
   Overlap each stroke by a little to prevent any gaps.As before, paint the mail box once with the flap closed, and once with the flap open.
   
   Never close the flap while the paint is wet, or it will get stuck.
   
   If you left the flag on, remember to move the flag up and down as you paint, so that you get the areas under it. , If you don't wait for the paint to dry, it may not cure properly, and result in a sticky, tacky finish. , Spray them with your primer first.
   
   Once the primer dries, apply your outdoor spray paint.
   
   You can match the color to your mailbox, of you can experiment with different colors.
   
   For example, if you painted your mailbox white, try painting the latches and hooks black, and the flag a bright red.If the parts are loose, simply set them down onto a plastic tablecloth or masking paper.
   
   Be sure to flip them over so that you can get the back too.
   
   If the parts are still on the mailbox, then pull off any painters tape and plastic bags.
   
   Make sure that the paint on the mailbox is dry, then wrap the mailbox in masking paper or plastic, but leave the hooks, latches, and flag exposed.
   
   Wait until the paint dries before removing the paper/plastic from your mailbox. , Just because a paint is dry to the touch does not necessarily mean that it is fully cured and dry underneath.
   
   Refer to the label on your paint can for specific drying times.
   
   Some paints require only 2 to 4 hours to dry and cure, while others may need anywhere from 6 to 72 hours.
   
   Keep in mind that both temperature and humidity levels will affect drying times.
   
   Paint will dry faster when the air is dry, and it will dry slower when the air is humid. , Get out the screws from before, and screw everything back on tightly. , Make sure that it is facing the right way and hanging straight., This will make it easier to paint it.
   
   Most numbers can be just unscrewed.
   
   If they were hammered into the post, you might have to pry them off; keep in mind that if you pry the numbers off, you might bend them.
   
   If that happens, you will have to get new ones., This will not only remove any mold, moss, and mildew, but it will also give you a smoother surface to work on., You can use wood filler or paste.
   
   Smooth the paste down using your fingers.
   
   If the paste is too sticky and grainy, dip your finger in water, and try smoothing it down again.
   
   You don't have to do this, but it will give you a smoother finish. , Use a large paintbrush or a foam roller to apply an outdoor quality primer.
   
   This will give you a smoother surface to work on.
   
   Wait for the first coat to dry before applying a second one. , You can use a large paintbrush or a foam roller to do this.
   
   Apply the paint using long, even strokes. , Sometimes, one coat will be enough, but you might need a few more in order to get enough coverage.
   
   Allow each coat to dry before applying another one. , You can leave them as they were, or you can update them with a new look.
   
   Prime the numbers using an outdoor quality spray paint primer that's intended for metal.
   
   Once the primer dries, apply an outdoor quality spray paint.
   
   You can use any color you want, but a contrasting color might make them more visible., Just because a paint feels dry does not mean that it is fully dry underneath.
   
   Check the label on your paint can for exact drying times.
   
   Some paints require only 2 to 4 hours to dry and cure, while others require anywhere from 6 to 72 hours. , If the letters were screwed in, simply place them back on the post and put the screws back in.
   
   If the letters were hammered in, you might remember how difficult it was to remove them.
   
   To prevent this from happening again, consider getting some screws, and screwing them in instead. , You can leave it blank, or you can add some designs onto here.
   
   This section will give you a few ideas.
   
   You don't have to use all of them; just choose the ones you like the most.
   
   Make sure what you are using an outdoor quality paint.
   
   When you are finished painting your design, consider letting the paint dry, then spraying the mailbox with a clear, outdoor sealer.
   
   This will help protect your beautiful work. , This works great on white mailboxes.
   
   Choose some paint in bright colors, then ask your family members to write their names on the mailbox.
   
   If you want, they can even leave behind handprints or a little drawing. , If you are using adhesive stencils, simply place them down onto the mailbox where you want the designs to go.
   
   If you are using non-adhesive stencils, then secure them using painters tape.
   
   Apply the paint using a foam brush or a stencil brush.
   
   You can also use spray paint instead.
   
   Whatever paint you choose to use, make sure that it is outdoor quality.
   
   Once you are done, pull the stencil off and let the paint dry.
   
   Consider using a color that contrasts with your mailbox; this will make the designs more visible.
   
   For example, if your mailbox is black, try using white for the stenciled part. , For example, the body of the mailbox can be one color, and the flap can be another.
   
   This will add some visual interest to your mailbox. , You can use the same color as the rest of your mailbox, or a contrasting color to make it more interesting. , You can paint them directly using a paintbrush, or you can sketch the design out first with a pencil, and then paint over that.
   
   Here are some ideas to get you started:
   Paint something garden related, such as butterflies, ladybugs, tulips, daffodils, or ivy.
   
   Paint some random designs, such as spirals and swirls.
   
   If you like animals, you can paint your favorite animal, or animals commonly found in gardens, such as birds, frogs, and squirrels.
   
   Paint the mailbox to look like something different, such as a cat, cow, or dog (the flap of the mailbox becomes the mouth).
   
   You can even paint it to look like a bus, barn, house, or anything else that has a similar shape.
3. 3

   Step 3: Remove all parts from the mailbox

4. 4

   Step 4: if possible.

5. 5

   Step 5: Clean everything using an all-purpose cleaner.

6. 6

   Step 6: Rinse the mailbox with water and let it dry.

7. 7

   Step 7: Use a wire brush

8. 8

   Step 8: steel wool

9. 9

   Step 9: or sandpaper to remove any rust or mold.

10. 10

    Step 10: Wipe away any dust residue using a tack cloth.

11. 11

    Step 11: Cover any parts you don't want painted with painters tape.

12. 12

    Step 12: Check the weather conditions.

13. 13

    Step 13: Work outside or in a well-ventilated area.

14. 14

    Step 14: Apply spray paint primer to the mailbox.

15. 15

    Step 15: Wait for the primer to dry before applying a second coat.It is better to apply multiple thin coats than one thick coat.

16. 16

    Step 16: Apply the first coat of spray paint once the primer driers.

17. 17

    Step 17: Allow the paint to dry before applying a second and third coat.Allow each coat to dry before applying a second or third one.

18. 18

    Step 18: Prime and paint the flag

19. 19

    Step 19: and latches.

20. 20

    Step 20: Let the paint on all parts dry completely before moving on.

21. 21

    Step 21: Attach the flag

22. 22

    Step 22: and latches back onto the mailbox.

23. 23

    Step 23: Screw the mailbox back onto the wall or post.

24. 24

    Step 24: Remove any numbers from the post.

25. 25

    Step 25: Sand the post down if you have not already done so.

26. 26

    Step 26: Consider filling in any holes and cracks.

27. 27

    Step 27: Apply two coats of paint primer to the post.

28. 28

    Step 28: Paint the post using an outdoor quality paint.

29. 29

    Step 29: Wait for the paint to dry before applying a second or third coat.

30. 30

    Step 30: Consider priming and painting the numbers.

31. 31

    Step 31: Let the paint dry all the way before moving on.

32. 32

    Step 32: Re-attach the letters.

33. 33

    Step 33: Consider painting a design onto your mailbox.

34. 34

    Step 34: Create a whimsical mailbox with your family.

35. 35

    Step 35: Use stencils to create unique designs.

36. 36

    Step 36: Paint different parts of the mailbox a different color.

37. 37

    Step 37: Consider painting the inside of your mailbox.

38. 38

    Step 38: Paint some designs onto the mailbox.

Detailed Guide

About the Author