How to Make a Foam Rocket

Step-by-Step Guide

1. 1

   Step 1: Cut the foam pipe into one foot (0.3 meter) lengths.

   Do not tighten all the way. , The cable tie should be inside the pipe. ,, Be careful of sharp edges! , Experiment with different shapes, sizes, and number of fins. , If you have a hot glue gun, use it.
   
   Otherwise, use glue suitable for fabric. , Place the rubber band (elastic band) over your finger and pull back on the bottom of the rocket.
   
   Move your arm forward in a throwing motion as you release the rocket.
2. 2

   Step 2: Attach a cable tie to the rubber band (elastic band).

3. 3

   Step 3: Place the rubber band/cable tie into the foam pipe

4. 4

   Step 4: leaving an end of the rubber band exposed.

5. 5

   Step 5: Attach the remaining cable tie securely to the end of the pipe so that the rubber band cannot be pulled through.

6. 6

   Step 6: Cut off the excess cable.

7. 7

   Step 7: Cut fins from the foam tray.

8. 8

   Step 8: Glue the fins to the foam pipe.

9. 9

   Step 9: Launch the rocket.

Detailed Guide

About the Author