How to Make a Wi Fi Booster Using Only a Can

Step-by-Step Guide

1. 1

   Step 1: Gather the required materials and tools.

   These are listed below under "Things You'll Need".
2. 2

   Step 2: Clean the can.. Make sure there is no residue left inside.

   ,, Do this using the Stanley knife or similar suitable safety knife. , Leave a little bit of metal to keep attached the part that will be the base (see the white line in the illustration). ,,, Place it so that the antenna pokes through the opening,, It's time to test how much your Wi-Fi is now boosted!
3. 3

   Step 3: Take the ring-pull off the can.

4. 4

   Step 4: Cut the end off the can where there's no opening.

5. 5

   Step 5: Cut around the end with the opening almost all the way.

6. 6

   Step 6: Cut along the middle of the can in a straight line

7. 7

   Step 7: opposite to the piece of metal attaching the base.

8. 8

   Step 8: Being careful

9. 9

   Step 9: open up the middle piece of metal by bending it until it vaguely resembles the shape of a radar dish.

10. 10

    Step 10: Place the completed Wi-Fi booster on your router.

11. 11

    Step 11: Stick the base of the can to the router with a small piece of poster tack or other suitable adhesive.

Detailed Guide

About the Author