How to Seal Concrete

Step-by-Step Guide

1. 1

   Step 1: Get your supplies ready.

   You will need a broom or blower and a good concrete cleaner.
   
   For applying the sealer you will need a roller, a garden pump sprayer, or a pneumatic low pressure sprayer.
   
   You will likely want to have a good pair of rubber gloves and wear eye protection.
2. 2

   Step 2: Clean the surface of the concrete thoroughly.

   Use a good cleaner that will remove any oils, stains, or grease.
   
   Use a stiff bristled brush or broom to scrub the surface and rinse it off with a hose.
   
   For the best results, use a power washer.
   
   Before applying the sealer make sure the concrete is dry. , Doing so after cleaning the surface makes for a smooth even substrate for the sealer to adhere to. , Shaking the sealer may cause bubbles which can adversely affect the appearance of the sealed surface. , This is especially important if you are using a sealer that will add color or sheen to the concrete.
   
   Make sure you complete the entire project at one time. , This will vary according to the manufacturer’s recommendations.
3. 3

   Step 3: Patch or repair any defects in the concrete.

4. 4

   Step 4: Before applying the sealer make sure to stir it thoroughly but do not shake it.

5. 5

   Step 5: Apply the sealer with a roller or sprayer in an even pattern

6. 6

   Step 6: making sure to avoid puddles.

7. 7

   Step 7: Allow the sealer time to dry before using the concrete surface.

Detailed Guide

About the Author