How to Make LEGO Friendship Bracelets

Step-by-Step Guide

1. 1

   Step 1: Choose your colors.

   Organize and color coordinate your embroidery thread and LEGO pieces for the best presentation.
   
   You can do a solid color, two, or three different colors per bracelet.
2. 2

   Step 2: Layer the LEGO pieces.

   Place about two to three LEGO pieces on top of one another. , Use a 3/32" (2.38 mm) drill bit to create two holes in each LEGO block, just inside of the two outer pegs so that you create a "triangle". , Detach the pieces from each other and lay them down. , Allow a few inches of length, which can be re-cut at the end.
   
   Prepare to use three strands of thread for each brick.
   
   Arrange the embroidery thread colors side by side. , Fold the threads in half and thread the loop part in the LEGO brick.
   
   Each LEGO brick will now have six strands of embroidery thread; three on each side. , Insert the loose strands through the loop.
   
   Ensure that you pull tight so its secured. , Use the thread strands and create a 1 1/2 inch (3.8 cm) braid.
   
   Make a small knot at the end and cut the remaining loose thread.
   
   If you wish to make it longer, make sure both sides are equal in size to allow the LEGO block in the center of the bracelet. ,,,
3. 3

   Step 3: Drill in the holes.

4. 4

   Step 4: Disassemble the LEGO pieces.

5. 5

   Step 5: Measure and cut the embroidery thread.

6. 6

   Step 6: Thread three strands in each hole.

7. 7

   Step 7: Create an initial "knot".

8. 8

   Step 8: Braid the bracelet.

9. 9

   Step 9: Repeat for the other side of the LEGO.

10. 10

    Step 10: Wear your Lego Friendship Bracelet!

11. 11

    Step 11: Finished.

Detailed Guide

About the Author