How to Create a Track Switcher on MCPE Master
Find a big area to build in., Place down three normal tracks., Lay down a detector rail at one end of the track., Connect one more piece of rail to the detector., Place a block of your choice on each side of the most recently placed block., Break...
Step-by-Step Guide
-
Step 1: Find a big area to build in.
The elimination of any passive mobs is unnecessary. -
Step 2: Place down three normal tracks.
Three is a good amount if you are practicing, but many more may be needed to create an actual large railroad. , You should have a total of four pieces on the ground. , This is critical to the creation of the railroad. , These are marker blocks. , One of the rails should turn into a curve. , You can choose to get in it, put a mob in it, or just push it to get it moving. , The track will now switch. -
Step 3: Lay down a detector rail at one end of the track.
-
Step 4: Connect one more piece of rail to the detector.
-
Step 5: Place a block of your choice on each side of the most recently placed block.
-
Step 6: Break your marker blocks and replace them with rail.
-
Step 7: Drop down a minecart.
-
Step 8: Watch as the minecart rolls over the detector.
Detailed Guide
The elimination of any passive mobs is unnecessary.
Three is a good amount if you are practicing, but many more may be needed to create an actual large railroad. , You should have a total of four pieces on the ground. , This is critical to the creation of the railroad. , These are marker blocks. , One of the rails should turn into a curve. , You can choose to get in it, put a mob in it, or just push it to get it moving. , The track will now switch.
About the Author
Eric Jenkins
A seasoned expert in education and learning, Eric Jenkins combines 6 years of experience with a passion for teaching. Eric's guides are known for their clarity and practical value.
Rate This Guide
How helpful was this guide? Click to rate: