How to Replace a Trojan Uvmax Ultraviolet Lamp

Step-by-Step Guide

1. 1

   Step 1: Open a tap downstream of the UV unit to release pressure.

   Then, close this tap. , Let the system cool for 10 minutes.,,,, Use other hand to unscrew lamp from sleeve bolt by holding lamp tab.
   
   Then Remove o-rings and sleeve bolt from sleeve., Caution:
   Over tightening will break the sleeve., Make sure lamp/sleeve assembly is centered.
   
   Caution:
   Over tightening will break the sleeve., Then push the safety cap back in place.
2. 2

   Step 2: Unplug power supply and all peripheral devices such as junction boxes and remote alarms.

3. 3

   Step 3: Remove the safety cap from top of the UV System Chamber.

4. 4

   Step 4: Pull the lamp plug off the lamp end (do not pull by lamp plug's cable).

5. 5

   Step 5: Hold by sleeve bolt to remove lamp/sleeve assembly.

6. 6

   Step 6: Hold sleeve bolt with one hand.

7. 7

   Step 7: Reinstall the o-rings

8. 8

   Step 8: and then Screw UV lamp into sleeve bolt hand-tight.

9. 9

   Step 9: Place the lamp and sleeve assembly back into the chamber.

10. 10

    Step 10: Align connections by rotating ring clamp (if equipped) to push lamp plug onto end of lamp.

Detailed Guide

About the Author