How to Replace the Top and Bottom Spray Arm Seals

Step-by-Step Guide

1. 1

   Step 1: Take out the upper dish rack so it can be laid on a flat surface.

   Depress the tab and lift up on them.
   
   Do the same for the other side. ,,, Lift off the supply tube and put it aside.  The seal that needs to be replaced is on the bottom of the upper spray arm. , Make sure it’s flush on the mount and re-insert the one screw.
   
   We’re ready to reassemble.Tip:
   Don’t over tighten the screw. , Pull the tracks forward and line them up with the racks wheels.  Begin with the front wheels and push the rack along the tracks.
   
   Now reinstall the rack stops.  Make sure the bendable tab is on top and stick the bottom of the tab in first, press it into place until it locks. ,
2. 2

   Step 2: To remove the rack remove the two rack stops using a flat blade screwdriver.

3. 3

   Step 3: Slide the upper rack forward

4. 4

   Step 4: off the tracks and push the two racks that will stick out back inside. 

5. 5

   Step 5: Set the rack with the arm facing up

6. 6

   Step 6: on top of the dishwasher or counter to do the repair.

7. 7

   Step 7: Remove the Phillips screw that connects the supply tube to the mount.

8. 8

   Step 8: Put the new seal into place and line up the supply tube.

9. 9

   Step 9: Reinstall the rack.

10. 10

    Step 10: You’ve just repaired the top and bottom spray arm seals in your dishwasher!

Detailed Guide

About the Author